Use a Bluetooth Snorkeling Case to Take Photos Underwater

When using a dedicated Bluetooth snorkeling case, you can quickly launch the camera when you are swimming or diving, and easily take photos, zoom in or out, and switch between modes.

 

• Purchase a dedicated Bluetooth snorkeling case from an official channel.

• Before using your device underwater, refer to the snorkeling case user guide to ensure that the case is fully sealed.

• Refer to the depth and duration limits of the snorkeling case. Do not use your device in deep water for an extended period of time.

1. Swipe down from the status bar to open the notification panel, then touch to enable Bluetooth on your device.

2. Refer to the snorkeling case user guide to enable Bluetooth on the case, and place the case close to your device.

3. Your device will automatically detect the snorkeling case and prompt you to connect to it.

4. After the connection is set up, install the snorkeling case according to the instructions and ensure that the case is airtight. Double-press the Power button to enter Underwater mode. You can then:

   • Take a photo: Press the shutter button.

   • Take a burst photo: Press and hold the shutter button.

   • Zoom: Move the zoom joystick.

   • Switch between photo and video modes: Double-press the Power button.

   • Pause/Resume recording: Press the shutter button when recording.

   • End recording: Double-press the Power button.

   • Switch between the front and rear cameras: Press the Power button three times.

   • Turn the screen on or off: Press the Power button.

   • Disable Bluetooth on the snorkeling case: Press and hold the Power button for 2 seconds.

5. After you have finished shooting, take your device out of the water and follow the onscreen instructions to exit Underwater mode.