How do I install lenses on my Browline Eyewear
Applicable products:
How do I install lenses on my Browline Eyewear |
To install lenses on your HUAWEI Eyewear 2 Browline Eyewear, perform the following steps.
Removing the decorative lenses
The eyewear comes with decorative lenses, which should not be worn for extended periods of time.
- Unfold the arms, use a Phillips screwdriver to loosen the screw that connects the decorative lens and arm, and remove the screw, washer, and T-shaped washer in sequence to separate the decorative lens from the arm.
- Loosen the screw that connects the decorative lens and the bridge, and remove the screw, metal washer, and T-shaped washer in sequence to separate the decorative lens from the bridge.
- Repeat steps 1 and 2 to separate the other decorative lens from the arm and bridge.
Installing lenses
This product comes with screws of three lengths (including screws assembled on the product). Please measure the thickness of the lens edge first, and select screws of the appropriate length.
Thickness of the Lens Edge (mm) |
Corresponding Screw |
Countersunk Hole for Screw Recommended or Not |
2.5–3.0 |
Short screws (length: 3.6 mm) |
No |
3.0–5.0 |
Medium length screws (length: 4.2 mm) |
Yes |
> 5.0 |
Long screws (length: 5.0 mm) |
Yes |
- Secure the lens to the arm using a T-shaped washer, metal washer, and screw in sequence.
- Secure the lens to the bridge using a T-shaped washer, metal washer, and screw in sequence.
- Repeat steps 1 and 2 to install the other lens on the arm and bridge.
If the lenses cannot be attached or are loose after being attached, perform the following steps:
- Lens are loose:
- The screws may be too long. Replace these screws with short or medium length screws. If the lenses still can't be secured using the shortest screws, remove the T-shaped washer and use a leveling washer instead.
- The holes on the lenses for the screws are too large. It is recommended that you visit a professional eyewear store for assistance.
- If the lenses cannot be attached:
- The screws may be too short. Replace these screws with long or medium length screws, and drill countersunk holes on the lenses.
- The holes on the lenses for the screws are too small. It is recommended that you visit a professional eyewear store for assistance.
Thanks for your feedback.